Home > News
Animal feed Pellet machine trouble removal
Malfunction: The reasons of flat die blocked when machine power on: 1. The flat die hole is blocked; 2. Die rust or finish is poor; 3. The gap between the flat die and rollers is too big; 4. Mixed feed moisture content is too low; 5. Crude fiber content is too much.  Solution: 1. Use steel nails or electric drill to get hole through; 2. Using oil feed grinding; 3. Adjust the suitable gap between the flat die and rollers; 4. Appropriate increase water content. 5. Reduce the crude fiber content, increase the raw material powder content.
Malfunction: The reasons of pellet with too much powder: 1. The mixed feed moisture content is too low; 2. Mixed feed moisture content is too high. Solution: 1. To improve moisture content;2. Reduce the moisture content.
Malfunction: The reason of discharged pellets lower and lower: 1. The gap between flat die and roller is too large; 2. Low moisture content. Solution: 1. Adjust suitable gap between flat die and roller;2. Increasing water content.
Malfunction: Finished pellet too hard reasons: 1. The mixture feed moisture content is low; 2. The gap of flat die and roller is too small. Solution: 1. Increasing moisture content;2. Appropriate increase the gap between flat die and roller.
Malfunction: Finished pellet too soft rough surface reasons: 1. The moisture content is improper; 2.New flat die using. Solution: 1. Adjust the moisture content; 2. Flat die for grinding processing.
Malfunction: Feed pellet machine suddenly shut up reasons: 1. The line voltage drop suddenly; 2. Have a hard thing or a metal inside. 
Solution: 1. Check the line fault 2. Stop machine running and clean.